Bolid Signal-10 Manual do Utilizador descarregar pdf (Página 7)

SIGNAL-20P SPECIFICATIONS

The device would generate messages and transmit them to the net

controller through the RS-485 interface for some events listed below, with

data transfer rate being equal to 9600 bps and transmission type being

half-duplex:

“ARMED” - Detector status monitoring has been turned

“ARM FAILED” - Arming has failed due to the actuated status

of detector

“FIRE SIGNAL” - Fire conditions have been detected

“FIRE PREALARM” - Fire signal has been received and fire is

probable

“FIRE ALARM” - Fire alarm

“LOOP TRBL OPEN” - Open-circuit failure in the alarm loop

“RELAY TRBL OPEN” - Open-circuit failure of relay output load circuit

“LOOP TRBL SHORT” - Short circuit in the alarm loop

“RELAY TRBL SHORT” - Short-circuit failure of relay output load circuit

“TAMPER ALARM” - Device or detector case is opened

“TAMPER RESTORE” - Device or detector case is closed

“RELAY RESTORE” - Relay output load circuit has been restored

“MANUAL TESTING” - The device diagnostic mode has been run

“ARM DELAY” - The delay is counting after the arming com-

mand having been received

“DISARMED” - The detector status is not monitored

“DEVICE RESTART” - The device has been restarted

“ALARM RESET” - Fire alarm has been canceled, the detectors

being monitoring

“POWER FAILED” - Device power supply is out of range

“POWER RESTORE” - Device power supply is restored after failure

“AUX ZONE RESTORY” - Auxiliary loop restored

“AUX ZONE ALARM” - Auxiliary loop alarm

“SILENT ALARM” - Silent zone alarm

“ENTRY ALARM” - Entry zone alarm

“READY TO ARM” - Zone disarmed. Ready for arming

“NOT READY TO ARM” - Zone disarmed. Arming is impossible due to

the actuated detector

“INTRUSION ALARM” - Intrusion alarm

1 2 3 4 5 6 7 8 9 10 11 12 ... 56 57

Sem comentários

Bolid Signal-10 Manual do Utilizador Página 7