Bolid Signal-10 Manual do Utilizador descarregar pdf (Página 50)

Orion ISS

www.bolid.com

Table 7. Programmable Auxiliary Loops Available Statuses

Status

Code

Status

Code

Status

1 AC Power Restored 77 Too Low Level

2 AC Power Failed 78 Normal Temperature

3 Intrusion Alarm 82 Heat Sensor Failed

17 Arming Failed 109 Disarmed

24 Armed 118 Entrance Alarm

35 Auxiliary Zone Restored 130 Pump On

36 Auxiliary Zone Alarm 131 Pump Off

37 Fire Alarm 149 Tamper Alarm

38 Auxiliary Zone Alarm-2 152 Tamper Restored

39 Fire Equipment Restored 198 Power Failed

41 Fire Equipment Trouble 199 Power Restored

44 Fire Prealarm 200 Battery Restored

45 Loop Open Failure 202 Battery Failed

58 Panic Alarm 204 Service Required

71 Low Level 206 Low Temperature

72 Normal Level 214 Loop Short Failure

74 High Level 216 Fire Signal

75 Too High Level 220 Gas Press Signal

76 High Temperature 223 Patrol Check

While programming resistance thresholds for statuses of an alarm loop of the Type 12, it needs to know

strictly the resistance range for each of the loop status. As it is quite a difficult task, the actual alarm

loop resistances can be approximately calculated based on resistance values expressed in ACD units

and measured by the Signal-10 device using the formula:

281

loop

−=

ADC

R , [KΩ],

where R

loop

is the actual resistance value of an alarm loop and

ADC is the ADC-value of the resistance measured by the Signal-10 device.

This formula enables adequately calculating resistance values of the loop ranged from 0.1 KΩ to

50 KΩ. Reading the ADC values is provided either by S2000/S2000M console tools or by UProg Con-

figuration Tool while programming the loop (see Figure 13, the page 75 of this Manual).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

Sem comentários

Bolid Signal-10 Manual do Utilizador Página 50