Bolid Signal-10 Manual do Utilizador descarregar pdf (Página 7)

Signal-10 General

In spite of functions and features implemented in the standalone mode (listed above), in cooperation

with the network controller the Signal-10:

¾ Monitors up to 10 fire alarm loops

o Of non-addressable types, namely:

− Smoke Two Threshold Alarm Loop (with recognizing responses from one or two

detectors within the alarm loop), Type 1;

− Combined Fire Single Threshold Alarm Loop (both smoke and heat fire detectors can be

brought in the alarm loop), Type 2;

− Heat Two Threshold Alarm Loop, Type 3;

o or/and Fire Threshold Addressable Alarm Loops of the Type 14 each of which can monitor

up to 10 connected detectors such as DIP-34PA, S2000-IP-PA, and IPR 513-3PA;

¾ Transmits to the Orion system messages about such events as changing states of alarm

loops, attempts to arm / disarm alarm loops, accidental conditions, troubles of the alarm loops,

the relay outputs, power and so on;

¾ Supports centralized control of its outputs, that control being caused by events in the Orion

system, such as alarms in intrusion partitions, granting /rejecting access through access points

etc.;

¾ Supports arming / disarming its alarm loops by means of electronic credentials (iButtons or

cards) via any reader in the system;

¾ Supports arming / disarming its alarm loops by means of system push-button keypads or from

the network controller;

¾ Being requested by the network controller, translates the current values of resistance of the

alarm loops with connected detectors and initiating devices;

¾ Stores in its non-volatile memory up to 512 events which cannot be translated to the network

controller in case of a temporal communication loss.

Arming/disarming of alarm loops is implemented by using electronic keys which can be Dallas

iButtons (Touch Memory devices) or other identifiers with 1-Wire (µ-LAN) output interface. To read

electronic keys an external reader is to be connected to the relevant input of the Signal-10. The de-

vice provides indication of current partition conditions and results of requested operations by means

of two-color reader LED.

The keys have to be pre-programmed, that is enrolled either into the device memory (if alarm loops of

the device are armed/disarmed locally) or into the network database (under centralized control) along

with the rights to arm/disarms the particular loops of the device assigned to each key.

7 www.bolid.com

1 2 3 4 5 6 7 8 9 10 11 12 ... 95 96

Sem comentários

Bolid Signal-10 Manual do Utilizador Página 7