Bolid Signal-10 Manual do Utilizador descarregar pdf (Página 67)

Signal-10 Installation

COMMISSIONING

During the process of commissioning and starting-up the particular security installation it can be nec-

essary to measure actual resistance values of alarm loops along with detector included. It can be

done either by tools of a network controller (see Alarm Loop Inspection section of this Manual, page

91) or by means of UProg configuration program which is installed on a PC connected to the Signal-

10 via one of the Bolid manufactured interface converters (it can be a PI-GR, S2000-PI, S2000-USB,

or USB-RS485).

To measure a current resistance value of the alarm loops connected to the Signal-10 by means of

UProg, select Alarm Loops tab and click on the splitter button at the centre of the right window bound.

The ACD Values pane will be expanded (see Figure 10). Press on the Read Button, and the Signal-

10 will display the measured resistance values in ADC units for all the alarm loops that are connected

to the device.

To collapse ADC Values pane toggle the splitter button once more.

Figure 10. Measuring Alarm Loop Resistances by Means of UProg

67 www.bolid.com

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 95 96

Sem comentários

Bolid Signal-10 Manual do Utilizador Página 67