Bolid Signal-10 Manual do Utilizador descarregar pdf (Página 57)

Signal-10 Operation Principles

57 www.bolid.com

POWER FAILED The input power voltage of the device is out of the normal range

POWER RESTORE The input power voltage of the device has come back to the normal range

ILLEGAL CODE An unknown electronic key is presented to the Signal-10 reader

USER’S CODE ENTR A user has presented to the reader an electronic key to arm/disarm alarm

loops

AUX ZONE RESTORE The Auxiliary alarm loop has been restored

AUX ZONE ALARM The Auxiliary alarm loop is broken

SILENT ALARM The alarm loop of the Type 11 has been broken

ENTRY ALARM The alarm loop of the Type 7 is broken, but the Alarm Delay for this loop

has not expired

READY TO ARM The resistance of the disarmed loop is within the normal range

NOT READY TO ARM The disarmed loop has been broken

INTRUSION ALARM An intrusion alarm has detected for the loop

In addition to the messages mentioned above, the network controller displays messages due to Pro-

grammable Auxiliary alarm loops in accordance with those statuses which were programmed for the

loops during configuring (see Auxiliary Alarms section of this manual, page 48).

For Fire Threshold Addressable alarm loops, the Signal-10 transmits the network controller both indi-

vidual condition changes received form addressable detectors or call points and generalized statuses of

all addressable zones matched with the loop by the Related Addressable Detectors parameter (see

Figure 14).

Following are the list of the individual conditions of addressable detectors and call points which can be

displayed by a S2000M console along with the identifiers of its partition, the device, and the addressa-

ble zone:

NORM The detector or call point has responded with the Norm condition

DUSTY The DIP-34PA detector is dusty and requires a service

TROUBLE The detector or call point has responded with the Trouble condition

FIRE The detector has actuated

MANUAL ALARM The manual call point has been activated

DETECTOR TEST The detector operability test has been implemented

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 95 96

Sem comentários

Bolid Signal-10 Manual do Utilizador Página 57